Collapse bottom bar
Fly Tying Fly Tying Materials

Tying the Whitlock Sheep Minnow

by Dave Whitlock   |  September 17th, 2012 1

Swimmer Sheep Minnows. Photo: Dave Whitlock

Before sitting down to tie Sheep Minnows, get a live minnow or a photo of the minnow you want to imitate. This will help you create a minnow of the correct color, length, width, and proportions. It pays also to learn about the habits of the minnows you plan to imitate.

I use a hook with a shank that is at least 4X-long because it provides consistent hooking efficiency on up-hook swimming streamers. With smaller (shorter shank) hooks, the fly’s head and back material can create a dodger-like effect that prevents the hook and point from penetrating the fish’s mouth. The farther back the point is from the head and the more up-angle the hook point are, the more effectively this fly hooks fish.

For the best possible hooking when a fish takes your fly, begin your strike with a deliberate, smooth line strip until you feel the fish, then make two or three fast hook sets with the rod.

I tip each body material’s butt end with a micro amount of Zap-A-Gap before I tie it to the hook, and I use only three or four wraps of 8/0 tying thread to secure the material. This keeps the nose small and neat.

The tying steps that follow are for the Swimming Sheep Minnow, but you can use them as a starting point for tying the Waker Sheep Minnow and the Deep Sheep Minnow.

The Waker Sheep Minnow has the same design as the Swimming Sheep Minnow except it is tied on a TMC 8089 nickel-plated, wide-gape, down-swimming hook. Up-swimming hooks for surface flies are poor hookers. Tie the floating head on the front 1/3 of the hook using deer hair and hollow plastic doll eyes. Trim the head to the size and shape needed to imitate the surface swimming action of the minnow of choice.

The Deep Sheep Minnow is tied almost identically to the Swimming Sheep except that instead of having a few turns of lead wire, it has a pair of metal barbell eyes on the lower side of the hook shank where you create the bend in Step1. Attach the eyes with figure-eight wraps and coat wraps with Zap-A-Gap. I paint the eyes and proceed with tying the minnow as described for the Swimmer. Choose the size and density of eyes to give you the sink rate you desire. Overcoat the eyes with five-minute Epoxy or Clear Wapsi Epoxy paint.

Dave Whitlock is a Fly Fisherman Editor-at-Large.

Continued – click on page link below.

Load Comments ( )

Related posts:

  1. Whitlock’s Sheep Minnow
  2. Whitlock’s 13 Indispensable Temperate Bass Flies
  3. Clouser Minnow
  4. Muddler Minnow
  5. Tying the STP Frog
back to top